The following document was contributed by Gilles Ganault on 2013-01-08.
Up and running in 5 minutes as a single user
This short document explains the main basic Fossil commands for a single user, i.e. with no additional users, with no need to synchronize with some remote repository, and no need for branching/forking.
Create a new repository
fossil new c:\test.repo
This will create the new SQLite binary file that holds the repository, i.e. files, tickets, wiki, etc. It can be located anywhere, although it's considered best practice to keep it outside the work directory where you will work on files after they've been checked out of the repository.
Open the repository
fossil open c:\test.repo
This will check out the last revision of all the files in the repository, if any, into the current work directory. In addition, it will create a binary file _FOSSIL_ to keep track of changes (on non-Windows systems it is called .fslckout).
Add new files
fossil add .
To tell Fossil to add new files to the repository. The files aren't actually added until you run "fossil commit. When using ".", it tells Fossil to add all the files in the current directory recursively, i.e. including all the files in all the subdirectories.
Note: To tell Fossil to ignore some extensions:
fossil settings ignore-glob "*.o,*.obj,*.exe" --global
Remove files that haven't been committed yet
fossil delete myfile.c
This will simply remove the item from the list of files that were previously added through "fossil add".
Check current status
This shows the list of changes that have been done and will be committed the next time you run "fossil commit". It's a useful command to run before running "fossil commit" just to check that things are OK before proceeding.
To actually apply the pending changes to the repository, e.g. new files marked for addition, checked-out files that have been edited and must be checked-in, etc.
fossil commit -m "Added stuff"
If no file names are provided on the command-line then all changes will be checked in, otherwise just the listed file(s) will be checked in.
Compare two revisions of a file
If you wish to compare the last revision of a file and its checked out version in your work directory:
fossil gdiff myfile.c
If you wish to compare two different revisions of a file in the repository:
fossil finfo myfile
Note the first hash, which is the hash of the commit when the file was committed.
fossil gdiff --from HASH#1 --to HASH#2 myfile.c
Cancel changes and go back to previous revision
fossil revert myfile.c
Fossil does not prompt when reverting a file. It simply reminds the user about the "undo" command, just in case the revert was a mistake.